Body Finish
Filed aluminium 427 body Frame
4 inch powder coated steel frame
Driver side roll bar Body Hardware
Wiper system
aluminium jack hooks
Ferrules for doors, set of 8
Wheel well foam, uninstalled
Stainless fuel tank Interior
Latches/ handles for hood,trunk, doors
Windshield, sun visor, wind wings
Pedal assembly: Throttle, brake, clutch
Carpet, wool, not installed
Steering wheel, wood or leather wrapped
Throttle linkage
Leather covered dash
Fresh air ventilation system, drivers footbox Electrical
Wiring harness with relays and switches
Sealed battery with mounting tray and battery cutoff switch
Headlights, tail lights, turn signals, license plate light
Gauges, full set Engine Compartment
Radiator with radiator tubes
Oil cooler, complete assembly
FE motor mounts, 427, set of 2
Steel steering shaft
Painted steel side pipes, with headers, not installed Transmission
Transmission mount for Tremec or Top Loader Suspension
Kirkham aluminium reproduction differential, with mounts
Differential breather hose
Driveshaft
Half shafts with CV joints, set of 2
Kirkham 4 wheel independent billet aluminium suspension
Coil-over Shocks (dampers) w/ Hyperco springs Brakes
Wilwood 4 piston calipers front and rear, vented disks, E-brake
Stainless brake lines
Reservoirs, brake and clutch, billet aluminium Tires and Wheels
Tires, 245/60/15 front, 275/60/15 rear with Trigo aluminium wheels