---

Kirkham 427 Manual	Table of Contents

---

Hood, Door & Trunk Latches

---

Hood Latches

Parts:

• hood latches (l & r)
• hood handle (2)
• hood handle trim ring (2)
• trim ring bolt (4)
• trim ring nut (4)
• compression spring (2)
• 3/8” sae washer (2)
• cotter pin (2)
• 10-32 x 3/4” bolt (4)
• 3/16” washer (8)
• 3/16” jet nut (4)

Tools:

• small phillips head screwdriver
• 1/4” wrench
• 3/8” wrench
• ratchet
• 1/4” socket
• needle nose plyers

1. Install the latches. Make sure the square hole on the latch is oriented to the hole in the frame. Also, make sure the latch will swing out to the rear, not the front.
2. Install the trim rings. These can be installed on either side. Bolt them on with the tiny nuts and bolts included in the fastener kit.
3. Slide the handles in. The orientation of the handle should match that of thelatch arm. Slide the spring and washer on the end of each handle, and install the cotter pin.

---

Door Latches

Parts:

• left door latch
• right door latch
• door striker (2)
• 10-32x 3/4” oval head screw (16)
• 3/16”washer (8)
• 3/16”jet nut (8)

Tools:

• phillips head screwdriver
• small flat head screwdriver
• 1/4” wrench

1. Install the strikers. They just bolt on as shown above. (figure 1 & 2)
2. Install the latches. They install using four bolts, and there is a left and a right, so be careful. The drivers side is shown above.
3. Install the cover plate using a small flat head screwdriver.
4. Adjust the doors by orienting the striker forward or backward, using washers as shims.
5. After drivetrain installation, re-adjustment will be required

---

Trunk Latch

Parts:
• trunk handle
• trunk latch
• 10-32 x 1” oval head screw (2)
• 10-32 x 3/4” bolt
• 3/16” washer (6)
• 3/16” jet nut (4)

Tools:
• phillips head screwdriver
• 3/8” wrench
• 1/4” wrench

1. Bolt the latch to the underside of the trunk lid.
2. Orient the handle & gently push it in.
3. Insert screws from the handle side.
4. Gently and evenly screw the trunk handle in to place.

A small gap between the body and trunk frame where the handle bolts down is normal. Over tightening these bolts will close this gap, but will also flex the trunklid skin in and make the trunk look dented. Loosening the trunk handle bolts will fix this.

---

Back one page
Req. from 38.107.191.101 on Thursday, 09-Sep-2010 18:59:23 GMT
Change date: Monday, 02-Jul-2007 20:58:30 MDT
Kirkham Motorsports - Ph: 801-377-8224 - sales@kirkhammotorsports.com
Copyright © Kirkham Motorsports