| Kirkham 427 Manual | Table of Contents |
|---|
Jack Hooks
Parts:
- jack hook set (4 pieces)
- front upper spacer 2 1/4” (2)
- front lower spacer 4” (2)
- rear spacers 1 1/2” (4)
- 3/8-24 x 3 ¼ front upper bolt (2)
- 3/8-24 x 5 front lower bolt (2)
- 3/8-24 x 2 ½ bolt (4)
- 3/8” washer
- front grommet (4)
- rear grommet (4)
- ratchet
- 9/16” socket
Notice: Lifting the car with the jack hooks will damage the aluminum body!
Yes, this will also damage original cars. In the 1960's, winning races was far more important than keeping the nose wrinkle-free.
- install all 8 grommets.
- thread a washer onto every bolt
- thread all bolts onto the jack hooks
- add spacers
- push bolts and spacers through grommets in body
- tighten
note:Originally, the jack hooks were installed differently from car to car. The photos above show how we typically install them. To install them differently, keep in mind that you will need different lengths of spacers and bolts.
.jpg "front jack hook")
See the bend at the top of the front hooks...
.jpg "rear jack hook")
...while the rear hooks are straight on top.
Back one page
Req. from 38.107.191.101 on Tuesday, 07-Sep-2010 16:35:36 GMT
Change date: Monday, 02-Jul-2007 20:58:16 MDT
Kirkham Motorsports - Ph: 801-377-8224 - sales@kirkhammotorsports.com
Copyright © Kirkham Motorsports